Vu SoloSE

Discussion in 'Other satellite receivers.' started by tomeek.p, Feb 1, 2018.

  1. bibo1

    bibo1 Member

    Messages:
    62
    Likes Received:
    17
    Trophy Points:
    8
    Gender:
    Male
    Hi Johnny, hi toysoft,
    I just will inform you about my result in repair of my Solo se v2. During my tests with programming in telnet HT with the boot output of the et8500 bootloader i got the idea to try to get a backup of the may still existing programm wthin the flash -i did the following:
    1. connect cyprus board to the flash
    2. Via upload I get the realy still existing E2 part out.
    3. I connected the solo back to power supply, connected as well seriell with the HT. Nothing in was showing on
    the HT screen.I sought just again no result.
    4. dismantle the seriell. Switch the popwer again and I se that the usb just do a very quick illumination- i get a new openATV on that usb, put it in and belive it or not-I have a hundred % working Box again.

    Sorry for my bad english, I do not use it very often anymore.
     
    Johnny B. likes this.
  2. Johnny B.

    Johnny B. Technical Support Staff Member Moderator

    Messages:
    2,822
    Likes Received:
    1,504
    Trophy Points:
    113
    Gender:
    Male
    Location:
    Netherlands
    Home Page:
    Glad to hear it worked out for you in the end, and yes, sometimes you have to try several things for a good end result.
    Well done, and thanks for sharing your solution, it may help others. :)