solo 2 original error HW

Discussion in 'VuPlus Solo2 Hardware troubles and Repair support.' started by malpi, Oct 5, 2021.

  1. malpi

    malpi Member

    Messages:
    182
    Likes Received:
    12
    Trophy Points:
    18
  2. Johnny B.

    Johnny B. Technical Support Staff Member Moderator

    Messages:
    2,995
    Likes Received:
    1,584
    Trophy Points:
    113
    Gender:
    Male
    Location:
    Netherlands
    Home Page:
    I think, see if you get a rs232 terminal output from it.
     
  3. malpi

    malpi Member

    Messages:
    182
    Likes Received:
    12
    Trophy Points:
    18
    on one occasion it has started well but again it has returned to the error thanks
     

    Attached Files:

  4. Johnny B.

    Johnny B. Technical Support Staff Member Moderator

    Messages:
    2,995
    Likes Received:
    1,584
    Trophy Points:
    113
    Gender:
    Male
    Location:
    Netherlands
    Home Page:
    By reading this,

    EBI CS0: setting up NAND flash (primary)
    NAND device: Manufacturer ID: 0xad, Chip ID: 0xda (Hynix H27U2G8F2CTR-BC)
    NAND device: 256MiB, SLC, page size: 2048, OOB size: 64
    NAND device: Manufacturer ID: 0xad, Chip ID: 0xda (Hynix H27U2G8F2CTR-BC)
    NAND device: 256MiB, SLC, page size: 2048, OOB size: 64
    brcmnand brcmnand.0: 256MiB total, 128KiB blocks, 2KiB pages, 16B OOB, 8-bit, Ha
    mming ECC
    Bad block table found at page 131008, version 0x01
    Bad block table found at page 130944, version 0x01

    Than I think the nand flash chip, maybe an older image file may give a better result if it's uses less data space.
    Is so, then I think of the nand flash chip.

    Also test it without any other things connected, as the hdd, usb hubs etc.
     
  5. malpi

    malpi Member

    Messages:
    182
    Likes Received:
    12
    Trophy Points:
    18
    ok thanks I already saw the bugs in the Nand at the moment I have put this image BlackHole-2.0.0-vusolo2_usb and it is working I do not know what will hold thank you very much Jonny
     
    Johnny B. likes this.
  6. malpi

    malpi Member

    Messages:
    182
    Likes Received:
    12
    Trophy Points:
    18
    At the moment it is still working ok Thank you so much
     
    Johnny B. likes this.