I have a original vu+solo2, the remotecontroll suddenly is not working. I got a New one but the same problem is there, so the problem has to be With the reciever, any sugestion about what to do
I think, a good start is to check the front panel connector by measuring the voltages or by ohms. See here for more about this.
Remote Control could also be in mode 1 (VU+ Solo / VU+ Duo), instead of the mode 2... check this to be sure it has the mode for your Solo2/Duo2/Ultimo/Uno. TS
Hmm, could be... You can change the system code of your vu+ remote controller to the vu+ model that you want to control with. Mode 1 = SOLO/DUO Mode 2 = UNO Mode 3 and 4 = reserved for future models Press and hold 2 and 7 for three seconds untill the led turns red Press help Press 0001 or 0002 or 0003 or 0004 This will then be set to your selected vu+ model.