Dreambox600pwr not boot system, constantly flash red and green led ?

Discussion in 'Other satellite receivers.' started by mesa6256, Jul 7, 2019.

Tags:
  1. mesa6256

    mesa6256 New Member

    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    1
    Gender:
    Male
    The resiver was OpenLi image and I am wiping something out of the flash with the visual program. Now behave so that it can not connect to the dreamup program with the receiver.
    Can you help.
    Thanks in advance.
     
    mesa6256, Jul 7, 2019
    #1
  2. Johnny B.

    Johnny B. Technical Support Staff Member Moderator

    Messages:
    2,957
    Likes Received:
    1,576
    Trophy Points:
    113
    Gender:
    Male
    Location:
    Netherlands
    Home Page:
    You should always be able to flash these boxes when using dreamup and connected to a network and a rs232 serial cable.
    When you only tried it with network while the nand chip has been erased, then it could fail.
     
    Johnny B., Jul 8, 2019
    #2