C1125, + pad lifted

Discussion in 'Hardware troubles and Repair support.' started by crc_73, Jan 22, 2017.

  1. crc_73

    crc_73 New Member

    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    1
    Hi, this looks like somewhere I can get some help with this...

    The capacitor at C1125 got pulled off the board, and lifted the pad off the board, and was hoping someone could tell me a place on the parts side that is normally connected to the pad?

    I had a look at the pdf for the circuit board, but the pad is isolated on the parts side, so it's impossible to say where it might be going to.

    Just need the + side of the capacitor, the negative side is still ok, and I can determine where I might be able to rig it up once I know a point for the positive.

    Thanks.
     
  2. Johnny B.

    Johnny B. Technical Support Staff Member Moderator

    Messages:
    2,822
    Likes Received:
    1,504
    Trophy Points:
    113
    Gender:
    Male
    Location:
    Netherlands
    Home Page:
    I've tried to find the C1125, but couldn't find it.

    Where is it located.. print side, or parts side.
    Near the Uxxxx.
     
  3. crc_73

    crc_73 New Member

    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    1
    Hi,

    It's one of the large silver capacitors, right beside the HDMI port, parts side.
     
  4. Johnny B.

    Johnny B. Technical Support Staff Member Moderator

    Messages:
    2,822
    Likes Received:
    1,504
    Trophy Points:
    113
    Gender:
    Male
    Location:
    Netherlands
    Home Page:
    Ah okay I was looking to the ceramic caps but the C1125 goes on a original and clone board to the L1110 and R1130/1132 and the L1111 on the print side.
    See image for the locations.
     

    Attached Files: