I have a problem in uno4k se.
The u1954 system heats up a lot and squeaks. I tried to remove a few capacitors from the right side but it...
Can you upload the latest soft from evoe3hd from openatv? Does it have to be special to the clone?
Ok I find broken element SR1. R13 - 970 kohm and D4 (looks strange)- 970 kohm 560points. In SR3 have 0 ohm.
Thermister TH1 also is...
Pin 1 to 2, 160.1 ohm
Pin 1 to 3, 161.9 ohm
Pin 2 to 3, 2.3 ohm.
When measured it between the ground hot side and pin 2 and 3, M ohm down, up...
Diodes and cap is ok. The diodes had a value of about 520. Remove the IC2 and the short circuit to the ground disappeared.
There are no...
Yes, this is orginal psu.
I have problem with PSU. I replaced the F101 fuse because the time is broken. On IC1 on the leg of the Vcc I had a short to ground, IC1 replaced...
Replace this capcitor.
In JTAG pins 3,3 SDA SCL, have 3,3V. New chip did not help.
This is orginal. CPU is hot. JTAG is not active. I did a cfe update. Ok, I'll look for an older image.
RS log: https://paste.ofcode.org/vuzC6NTRVDGDFY92aYjWvQ
I have a problem with duo. Installing new image in the flash and I change C807. This did...
I have uno box. In this box HDMI not working. Upgrade the new image. Change a HDMI cable and
still hdmi not working.
R603 have 46 kohm
ok, I launched e2fsck
Warning: skipping journal recovery because doing a read-only filesystem check.
/dev/mmcblk0p4 contains a file system with...
I've tried to upload image with this file. Unfortunately, it's the same. Some files are not overwritten. I can't delete files from the flash...
I have a problem with solo 4k. I can not update from the usb port. It looks like the files are protected from writing. I wanted to give all chmod...
No I have this same problem.
Feeeeeeeeee etc. issue
I exchanged another NAND. I programmed it with openATV batch. Unfortunately, the tuner does not start. Does he not show the address from memory in...
Found low ohm. This fault value marked in red.
Ok, find problem with U825 regulator in this moment have corectly voltage in u817. Nothing has changed in the RS.