1. totoraga

    totoraga New Member

    Messages:
    6
    Likes Received:
    0
    Trophy Points:
    1
    Gender:
    Male
    Hello, I have a sound problem with my vu + solo se. After flashing the image in openpli 8.1, no more sound. I have reflashed several times and with various images and nothing has done. Do you have an idea of the problem ? thank you
     
  2. Johnny B.

    Johnny B. Technical Support Staff Member Moderator

    Messages:
    2,822
    Likes Received:
    1,504
    Trophy Points:
    113
    Gender:
    Male
    Location:
    Netherlands
    Home Page:
    I assume you mean the hdmi sound, but the RCA audio output works.

    In that case it could be the software/boot loader.
    It is difficult to find the right software for these receivers, my advice is to first check whether you are dealing with a clone, and which version.
    However, I worked with these receivers years ago, so today I wouldn't know how to work with the newer software.

    I think see if you can determine which receiver you are dealing with like the version, try an older version, or maybe the boot loader, or use the RCA audio for the sound, or use/try the S/PDIF
     
    raza05 likes this.
  3. totoraga

    totoraga New Member

    Messages:
    6
    Likes Received:
    0
    Trophy Points:
    1
    Gender:
    Male
    Hello johnny B,
    I tried the rca outputs and the same no sound. I think I have a problem with the sound management on my device. Yet worked well under VTI before flashing openpli 8.1. It's a V1 of solo se. Thank you for your help.
     
  4. Johnny B.

    Johnny B. Technical Support Staff Member Moderator

    Messages:
    2,822
    Likes Received:
    1,504
    Trophy Points:
    113
    Gender:
    Male
    Location:
    Netherlands
    Home Page:
    Yeah a new image file could mess up a receiver especially when it a clone and have a security chip.
    But still, and openpli written for the vu+ solo se as the stable version openpli-8.1-release-vusolose-20211017 should normally not give a problem.

    Maybe it helps when you search with google to VU+ Solo SE no sound after
     
    raza05 likes this.
  5. totoraga

    totoraga New Member

    Messages:
    6
    Likes Received:
    0
    Trophy Points:
    1
    Gender:
    Male
    Hello Johnny B,
    I confirm that this is not a clone but an original buy directly from the manufacturer VU +. What I cannot explain to myself is why a version which is specific to this model has this kind of failure, a clone I say not. So is it a problem with the firmware or the device? How to know ? Thanks for your ideas.
     
  6. Johnny B.

    Johnny B. Technical Support Staff Member Moderator

    Messages:
    2,822
    Likes Received:
    1,504
    Trophy Points:
    113
    Gender:
    Male
    Location:
    Netherlands
    Home Page:
    Yeah well, maybe it's due an audio setting, which were set different with vti than openpli.
    However, in that case you may expect that when you install a newer vti image, it should be solved.

    Another idea is, when you have the opportunity then try it also on another tv set.
     
    raza05 likes this.